Woods Equipment 211822 Torque Hardware, Install Grill Guard Optional, Mount Installation

Torque Hardware

Torque hardware to specifications listed below.

Slide fuel tank back into position and secure.

	TORQUE SPECIFICATIONS
			Wrench
Ref	Cap Screw	Qty	Size	Required Torque
4	M20 x 2.0P x 60 mm	2	30 mm	270 lbs-ft (367 N-m)
5	M20 x 2.5P x 50 mm	4	30 mm	270 lbs-ft (367 N-m)
8	M16 x 2.P x 50 mm	4	24 mm	125 lbs-ft (169 N-m)

Install Grill Guard (Optional)

1.Install grill guard bracket (10) to the right side of tractor frame in the lower set of holes using two cap screws (14), and hardened flat washers (17). Repeat for left side.

2.Place grill guard (11) between brackets (10) and secure using two cap screws (16) and four hex nuts (15). Secure hex nuts together but leave grill guard loose, it must be able to pivot freely. This allows the grill guard to swing down for maintenance.

3.Swing grill guard to the up position and secure using two clevis pins (12) and two klik pins (13).

4.Torque cap screws (14) to 270 lbs-ft.

10.1015429 Grill guard bracket

11.1015431 Grill guard

12.21332 1/2 x 1-1/2 Clevis pin

13.22411 3/16 x 1 Klik pin

14.307553 M20 x 2.5P x 50 mm Cap screw

15.307863 M16 x 2.0P Hex nut

16.34766 M16 x 2.0P x 60 mm Cap screw

17.57798 3/4 Hardened flat washer

DP7

Figure 9. Grill Guard Installed (Typical)

	11	10
13
	10	15
17		15
14	16	CD6756-2
	12

Figure 10. Grill Guard Installation

MAN0469 (9/9/2005) Mount Installation 7