CLEANING
After Each Use
●Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Inspect machine and replace worn or damaged parts.
●Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Remove the remainder using a
1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.
2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.
3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.
●Inspect machine and replace worn or damaged parts.
●Sand down scratches and the edges of areas of missing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).
●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.
TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Foaming oil | Low oil level | Fill reservoir |
| Air leaking into suction line | Tighten fittings |
| Wrong kind of oil | Drain and refill reservoir with non- |
|
| foaming oil |
| Moisture in oil | Keep oil temperature below 180° |
|
| and continue to operate as oil |
|
| dries out, or replace oil and purge |
|
| system if foaming is excessive |
|
|
|
Boom drops as dipperstick or | Check valve leaking | Clean or replace check valve |
bucket cylinder lever is activated |
| assembly |
while boom control is in raised |
|
|
position |
|
|
|
|
|
Jerky operation | Hydraulic hoses plumbed incor- | Check hydraulic plumbing sche- |
| rectly | matic and correct hose routing as |
|
| required |
|
|
|
MAN0306 (Rev. 5/23/2008) | Owner Service 21 |
|
|
