Install Slip Clutch Driveline
A.
29.Clutch shield
33. Vent plug/Dipperstick
60.12 mm x 1.5P x 65 mm Cap screw GR8.8
61.12 mm x 1.5P Hex lock nut
62.5/16 Flat washer
63.5/16 Lock washer
64.M8 x 1.25P x 20 mm HHCS
Figure 32. Slip Clutch Driveline Assembly
A new slip clutch, or one that has been in storage over the winter, may seize.
NOTICE
■A grade 8.8 metric bolt must be used to attach clutch driveline to gearbox.
1.Before operating slip clutch, make sure it will slip. Refer to SLIP CLUTCH ADJUSTMENT, page 18.
2.Place the shield (29) against gearbox and secure using four cap screws (64), lock washers (63) and flat washers (62). Torque bolts (64) to 12
3.Install driveline onto gearbox input shaft and secure with bolts (1) and nuts (2).
INSTALL SAFETY SHIELDING
Install Optional Chain Shielding
Full chain, rubber, or steel band shielding must be installed when operating in populated areas or other areas where thrown objects could injure peo- ple or damage property.
•If this machine is not equipped with full chain, rubber, or steel band shielding, operation must be stopped when anyone comes within 300 feet (92 m).
•This shielding is designed to reduce the risk of thrown objects. The mower deck and protec- tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing condition. It is possible for objects to ricochet and escape, traveling as much as 300 feet (92 m).
The optional chain shielding assemblies are ready for installation when you receive them.
1.Refer to Front & Rear Chain Shielding, page 42 and attach as shown by inserting the bolts from inside the cutter frame out through the shielding.
2.Install hardware as shown in the parts drawing.
Install Rubber Deflector
1.Attach rubber deflector (1) and link (2) to front of cutter using carriage bolts (3) and flange lock nuts
(4).
2.Insert bolts from inside the cutter frame out through the shielding.
1.Rubber deflector
2.Link
3.3/8 NC 1 Carriage bolt
4.3/8 NC Flange lock nut
Figure 33. Rubber Deflector Installation
FILL GEARBOX
NOTICE
■Gearbox is not filled at the factory. Prior to delivery to customer, make sure gearbox is filled only
1.Remove vent plug/dipperstick (9) on top of gearbox and plug on side of gearbox. Use 5/16" allen wrench to remove plug.
2.Make sure vent plug hole is clear.
3.Fill gearbox until oil runs out the side hole on gearbox. Use a high quality gear oil with a viscosity index of 80W or 90W and an API service rating of
4.Install side plug and vent plug.
MAN0680 (11/30/2007) | Assembly 31 |
|
|
