DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
NOTICE
■Gearbox was not filled at the factory. It must be serviced before operating cutter. (See Fill Gearbox, page 31). Failure to service will result in damage to gearbox.
Inspect cutter thoroughly after assembly to make sure it is set up properly before delivering it to the customer. The following check list is a reminder of points to inspect. Check off each item as it is found satisfactory, corrections are made, or services are performed.
___ | Check all bolts to be sure they are properly |
| torqued. |
___ | Check that all cotter pins are properly installed |
| and secured. |
___ | Check that PTO shaft is properly installed. |
___ | Check that gearbox is properly serviced and |
| seals are not leaking. |
___ | Check and grease all lubrication points as identi- |
| fied in, Lubrication Information, page 17. |
___ | Check that blades have been properly installed. |
DELIVERY CHECK
(DEALER’S RESPONSIBILITY)
___ Show customer how to make adjustments. Describe the options available for this cutter and explain their purpose.
___ Explain importance of lubrication to customer and point out lubrication points on cutter.
___ Present Operator's Manual and request that cus- tomer and all operators read it before operating equipment. Point out the manual safety rules, explain their meanings and emphasize the increased safety hazards that exist when safety rules are not followed.
___ Point out all guards and shielding. Explain their importance and the safety hazards that exist when not kept in place and in good condition.
___ For mounted units, add wheel weights, ballast in front tires, and/or front tractor weight to enhance front end stability. A minimum 20% of tractor and equipment gross weight must be on front tractor wheels. When adding weight to attain 20% of tractor and equipment weight on front tractor wheels, you must not exceed the ROPS weight certification. Weigh the tractor and equipment. Do not estimate!
___ Explain to customer that when equipment is transported on a road or highway, safety devices should be used to give adequate warning to oper- ators of other vehicles.
34 Dealer Check List | MAN0654 (Rev. 10/19/2007) |
|
|
