M1048 10" x 18" Metal Cutting Bandsaw
OPERATIONS
General
OPERATIONS
The Model M1048 will perform many types of operations that are beyond the scope of this manual. Many of these operations can be dangerous or deadly if performed incorrectly.
The instructions in this section are written with the understanding that the operator has the necessary knowl- edge and skills to operate this machine. If at any time you are experiencing difficulties performing any opera- tion, stop using the machine!
If you are an inexperienced operator, we strongly recom- mend that you read books, trade articles, or seek training from an experienced bandsaw operator before performing any unfamiliar operations. Above all, your safety should come first!
Always turn the saw OFF and allow the blade to come to a complete stop before using the vice! Failure to follow this caution may lead to injury.
Vise
The vise has a quick release feature that allows jaw width to be quickly adjusted when changing from one sized mate- rial to another.
To rapidly change the vise jaw gap, do these steps:
1.Turn the handwheel counterclockwise to relieve any pressure on the vise jaw.
2.Pull or push the jaw in the desired direction.
3.Finish tightening the jaw against the workpiece with the handwheel.
Note: Figure 14 shows correct methods of holding different workpiece shapes.
READ and understand this entire instruc- tion manual before using this machine. Serious personal injury may occur if safety and operational information is not understood and followed. DO NOT risk your safety by not reading!
