M1048 10" x 18" Metal Cutting Bandsaw
MAINTENANCE
General
Regular periodic maintenance on your SHOP FOX® Model M1048 will ensure its optimum performance. Make a habit of inspecting your machine each time you use it.
Check for the following conditions and repair or replace when necessary:
•Loose mounting bolts.
•Damaged or dull saw blade.
•Worn or damaged wires, or other unsafe condition.
•Clean after each use.
•Proper blade tension and coolant level.
•Check gear box fluid level.
•Change gear box oil (every four months if being used daily).
MAKE SURE that your machine | is |
unplugged during all maintenance pro- | |
cedures! If this warning is ignored, seri- | |
ous personal injury may occur. |
|
Cleaning
Frequently
This machine is equipped with a cutting fluid system, which pumps water and oil based cutting lubricants. It is especially important to make sure the internal working parts of the motor and electrical switches are kept dry and splash free.
MAINTENANCE
Lubrication
Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them. However, you must periodically lubricate threaded adjustment locations and check the gear box oil level.
Lubricate the following areas as follows:
•Blade Tension Mechanism: Open the main blade guard and drop a few drops of oil on the tension knob lead screw (see Figure 27).
Tension |
| |
Knob Lead | Blade Guide | |
Screw | ||
| ||
Figure 27. Main lubrication points. | ||
