Do not remove the ground- ing pin from any plug and always make sure all wiring to the machine is grounded before operating. Any elec- trical outlet and circuit that you plug your machine into must be grounded. Serious injury may occur if this warning is ignored!
220V Operation
The Shop Fox® W1679 can also be operated at 220 volts. To do this, you must purchase the optional 220V magnetic switch that is shown in the parts diagram at the back of this manual. Also, you will need a
The motor supplied with your new machine is rated at 1 HP and will draw approximately 7 amps during 220 volt operation. When choosing an outlet for this machine, consider using one with a 10 amp circuit breaker or fuse. When choosing plug and outlet, use a
SAFETY
Figure 8. NEMA-style 6-15 plug and outlet.
Never replace the circuit breaker with one rated at a higher amperage or damage to the circuit may occur, and a fire may result!
Extension Cords
We do not recommend using an extension cord for 220V equipment. Instead, arrange the place- ment of your machinery and installed wiring to eliminate the need for extension cords. If you must use an extension cord, make sure it is rated Hard Service (grade S) or better. The extension cord must always contain a ground wire and plug pin. Always repair or replace extension cords when they become worn or damaged.
Grounding
This machine must be grounded! See Figure 8. The electrical cord supplied with the Model W1679 is not equipped with a 220 volt plug. Use a plug with a ground pin. If your outlet does not accommodate a ground pin, have the outlet replaced by a qualified electrician or have an appropriate adapter installed and grounded properly. An adapter with a grounding wire does not guarantee the machine will be grounded. A ground source must be verified.
