12.Do not force the machine. The machine will do a safer and better job at the rate for which it was designed.
13.Use the correct tool. Do not force the tool or attachment to do a job for which it was not designed.
14.Wear the proper apparel. Do not wear loose clothing, neck ties, gloves, jewelry, keep long hair tied up, etc.
15.Remove all adjusting keys and wrenches. Before turning the machine on, make it a habit to check that all adjusting keys and wrenches have been removed.
16.Use proper extension cord. Examine the extension cord to ensure it is in good condition. Use the chart below to determine the correct length and gauge of extension cord needed for your particular needs. The amp rating of the motor can be found on its nameplate. If the motor is dual voltage, be sure to use the amp rating for the voltage you will be using. If you use an extension cord with an undersized gauge or one that is too long, excessive heat will be generated within the circuit increas- ing the chance of a fire or damage to the circuit. Only use an extension cord that has a ground pin. Immediately replace an extension cord if it shows any signs of damage.
17.Keep your footing stable and keep your balance at all times.
18.Do not leave machine the unattended. Wait until it comes to a complete stop before leaving the area.
19.Perform all machine maintenance, and follow all lubrication instructions in this manual.
20.Keep the machine away from open flame. Operating machines near pilot lights and/or open flames creates a high risk if dust is dispersed in the area. Dust particles and an ignition source may cause an explosion. Do not operate the machine in
21.If at any time you are experiencing difficulties performing the intended operation, stop using the machine! Then contact our service department or ask a qualified expert how the operation should be performed.
22.
SAFETY
Extension Cord Requirements
| Length And Gauge | ||
Amp Rating | 25ft | 50ft | 100ft |
#18 | #16 | #16 | |
#18 | #16 | #14 | |
| #16 | #16 | #14 |
| #14 | #12 | #12 |
| #12 | #12 | #10 |
| #10 | #10 | No |
Always wear safety glasses or goggles when operating equipment. Operating this equip- ment creates the potential for flying debris to cause eye injury. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be cer- tain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).
