Disc Sanding
To start disc sanding operations, do these steps:
1.UNPLUG THE SANDER!
2.Set the table tilt angle to the desired posi- tion by loosening the table lock knobs. Figure 17 shows the table at 45˚.
3.Plug the sander into the power supply.
4.Start the sander.
5.Hold the workpiece firmly in both hands as shown in Figure 18. Note— Always keep the workpiece on the side of the wheel that is rotating down toward the table. This will keep the workpiece from flying out of your hands from the rotational forces.
Flat Sanding
Flat sanding operations can be performed with the sanding belt in the vertical position or hori- zontal position.
To start flat sanding operations with the belt vertical, do these steps:
1.UNPLUG THE SANDER!
2.Make sure the sanding table is square to the belt.
3.Plug the sander into the power supply.
4.Start the sander.
5.Hold the workpiece firmly as shown in
Figure 19.
Figure 17. Table tilt set at 45˚.
Figure 18. Disc sanding.
Figure 19. Flat sanding operation.
OPERATIONS
