Woodstock W1712 instruction manual Cap screw location Work-Stop Fence

To start flat sanding operations with the belt horizontal, do these steps:

1.UNPLUG THE SANDER!

2.Remove the belt sanding table.

3.Loosen the cap screw shown in FIgure 20 to allow the sanding belt to rotate.

4.Rotate the belt to the horizontal position then tighten the cap screw loosened in step 3.

5.Install the work-stop fence (shown in Figure 21) to prevent the workpiece from running off the end of the sander.

6.Start the sander.

7.Hold the workpiece firmly and in contact with the work-stop fence as shown in

Figure 22.

OPERATIONS

-20-

Cap Screw

Figure 20. Cap screw location.

Work-Stop Fence

Figure 21. Flat sanding operation.

Figure 22. Flat sanding operation.