Woodstock W1811 manual Support Leg, Arm, =`li\*% Support leg installed, BefY $%,o

N(/((('Jc`[`e^KXYc\JXn

(,% Place a 12mm flat washer on the crosscut table
lock lever, then insert it through the crosscut
fence and thread the M12-1.75 T-nut onto the end				Lock Lever
approximately two turns.
(-%Align the T-nuts on the crosscut table with the
		T-Slot
T-slot in the face of the sliding table, then slide
the crosscut table into position on the sliding table
(=`^li\))) and tighten the crosscut table lock lever.
			T-Nut
	=`^li\))% Crosscut table installation.

(.% Place the crosscut table support leg on the extension arm, and attach it to the crosscut table with four

M6-1 x 16 cap screws, 6mm lock washers, and 6mm flat washers.

Attachment
Location
	Support Leg
Extension	J<KLG
Arm

	=`^li\)*% Support leg installed.
(/% Insert the two crosscut brace knobs with 8mm flat
washers through the crosscut table, then thread	Jlggfik	JhlXi\Elk	:ifjjZlk
the square nuts onto the ends of the knob threads	9Xi
(=`^li\)+#8). Slide the T-slot in the support bar		D/$(%),	KXYc\
over both T-nuts, and tighten the knobs (=`^li\)+#	9
9).
	=cXkNXj_\i
	/dd
	BefY		8
	D/$(%),o,'
	=`^li\)+% Installing support bar on
	crosscut table.

-21-