Woodstock W1811 manual Gfn\ifee\Zk`fe, jkIle, On Button, Stop Button

N(/((('Jc`[`e^KXYc\JXn

Gfn\i:fee\Zk`fe

Before connecting the saw to power, read through <c\Zki`ZXc section on GX^\() to verify that your setup follows the safety and circuit requirements for this machine.

Open the power connection box shown in =`^li\+,.

Power

Connection Box

=`^li\+,% Power connection box.

J<KLG

Connect the power wires to the terminals shown in =`^li\ +-, tighten the strain relief so the wires can't be pulled from the terminals, then close the power connection box.

K\jkIle

Once the assembly is complete and the power source is connected, test run your machine to make sure it runs properly and is ready for regular operation.

Ground

S

R

Figure +-.Power connection terminals.

The test run consists of verifying the following: 1) The motor powers up and runs correctly, 2) the stop button safety feature works correctly, and 3) the safety limit switches work correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, immediately stop using the machine, then review KiflYc\j_ffk`e^ on GX^\-).

If you still cannot remedy a problem, contact our Tech Support at (360) 734-3482 for assistance.

Before beginning the test run, review the power controls shown in =`^li\+. and :fekifcj=\Xkli\j on GX^\*.

-28-

ON Button

STOP Button

=`^li\+.% Main power controls.