Woodstock W1811 manual Countersink the holes you drilled in Jk\g. see, Insert see =`li\-+

N(/((('Jc`[`e^KXYc\JXn

.%	Use the 7⁄32" drill bit to drill holes completely
	through the new table insert.		(*Ð*)?fc\
		Cutaway View
/%	Install the 13⁄32" drill bit and use the included table		:flek\ij`eb
		of Drilled Hole
	insert as a guide to set the depth stop on your drill		]fiJZi\n?\X[
	press to countersink the holes.
			New
0%	Countersink the holes you drilled in Jk\g. (see
			Table Insert
	=`^li\-)), so the heads of the mounting screws can
	be recessed into the table insert when installed.
		.Ð*)?fc\
('% Install the dado blade at the thickness desired, mak-
		]fiJZi\nK_i\X[j
	ing sure the blade flange is used on the front of the
	of the blade behind the arbor nut, then lower the
	blade completely.
		=`^li\-)%Countersinking mounting holes.
((% Test fit the new table insert in the table, then sand
	the corners or trim the ends as necessary to get a
	precise fit.
()% Mount the new table insert into the table and check
	to make sure that it is flush with the top of the
	table. If necessary, remove the insert and sand the
	top of it down until it will mount up flush with the
	table top (see =`^li\-*).
(*% Close the cover over the blade and move the sliding
	table to the center of the saw.
(+% Connect the saw to power, start the motor, and
	slowly raise the blade into the zero clearance table
		=`^li\-*%New zero clearance table insert
	insert (see =`^li\-+).
		installed.
	Once the blade cuts through the top of the table
	insert, do not raise it higher than you anticipate
	your cuts to be. Doing so will compromise some of
	the zero-clearance qualities of your new table insert
	once the blade is subsequently lowered.

=`^li\-+%Dado blade raised into zero-

clearance table insert.

-39-

FG<I8K@FEJ