b)If you allow more than 30 seconds to elapse between key presses, the
If this occurs, simply repeat steps 3 through 5.
6.Pick another key and repeat steps 4 and 5 for all commands you wish the
7.When finished, press CANCEL and the active Source Key simultaneously to leave the Program Mode (or allow it to time out by waiting 30 seconds). Refer to Fig. 7.
You may now test the newly learned commands by pressing the keys you programmed.
When you press a key with a stored command, the active Source LED will blink indicating transmission of the command. No blinking will occur when keys are pressed that do not have commands.
Deleting Commands
If a command does not work, or you wish to change a command for any reason, proceed as follows:
8.Simply repeat steps 4 and 5. This will "write over" the original command, replacing it with the new.
If you wish to delete a command from a key or from a number of keys, proceed as follows:
9.Press DEL and a Source Key simultaneously. This puts you in the Delete Mode. The Status LED will blink Red.
Status LED
will go off 
| TV | VCR | SAT | CBL |
| DVD | TNR | CD | AUX |
Press and | POWER | T/V | MUTE | VOL |
|
|
| ||
Release the | 1 | 2 | 3 | VOL |
CANCEL Key |
| |||
4 | 5 | 6 |
| |
and the active |
| |||
Source Key | 7 | 8 | 9 | CH |
simultaneously |
| 0 |
| CH |
to leave the | ENTER | PR.CH |
| |
Program Mode | GUIDE |
|
| MENU |
|
| PAUSE |
| |
| REW |
| SEL | FF |
|
| PLAY | ||
|
|
|
| |
| EXIT |
| STOP | INFO |
PGM CANCEL DEL XFER
10.Press the key you wish to delete.
The Status LED will blink Amber briefly, indicating the command was deleted, then blink Red, waiting for your choice of another key.
A B C D
SEQ DELAY EDIT STEP
11. Repeat step 10 for all keys you wish to delete.
Fig. 7
12.When finished, press CANCEL and the active Source Key simultaneously to leave the Delete Mode (or allow it to time out by waiting 30 seconds).
PROGRAMMING SEQUENCES (Macros)
You can teach more than one IR command per key by using the Sequence Programming feature. This permits several commands to be executed by one key press to carry out a macro of several system functions. To teach a sequence of commands to a single key, do the following:
1.Press SEQ and a Source Key simultaneously. This puts you in the Sequence Mode. The Status LED will blink Green.
2.Now press the desired target key just as when doing regular IR programming (if a different Source key, press twice; if a Function key, press once).
The Status LED will be a steady Green, indicating that it is ready for IR input.
3.Press briefly the desired key on the "Teaching" Remote.
The
NOTES:
a)If the Status LED blinks Red twice, then steady Green, an error has occurred and the command has not been learned. When this happens, simply repeat step 3, but this time vary the distance and/ or the length of time you press the key on the "Teaching" Remote.
4
