Manuals / Brands / Lawn and Garden / Portable Generator / Xantrex Technology / Lawn and Garden / Portable Generator

Xantrex Technology FP 3000-12 Recommended Fuse:, Battery Cable Fusing, UL Listed Class T JLLN

1 48

Download 48 pages, 1.34 Mb

INSTALLATION

Battery Cable Fusing

A fuse is required by the NEC to protect the battery and cables. A UL Listed DC rated slow blow fuse must be installed in the positive (+) battery cable, within 18 inches of the battery.

Recommended Fuse: UL Listed Class T JLLN with a DC Rating. This fuse with fuse holder is available from your dealer.

For the FP3000-12

350 Amp Fuse & Holder PN# 84-4159-00

350 Amp Fuse Only PN# 84-4152-00

HARDWARE STACK-UP OPTIONS

+ (red)

COMPRESSION / RING TERMINAL		EXPLODED VIEWS
	NUT	OF FUSE ASSEMBLY
	NUT		RING / RING TERMINAL
	LOCK WASHER		RING / RING TERMINAL
	LOCK WASHER		NUT
	FLAT WASHER		NUT
	FLAT WASHER		LOCK WASHER
	BATTERY		LOCK WASHER
INVERTER	BATTERY
INVERTER	CABLE		FLAT WASHER
CABLE	CABLE	INVERTER	FLAT WASHER
CABLE		INVERTER	BATTERY
	FUSE	CABLE	BATTERY
			CABLE
	FUSE HOLDER		FUSE
	FUSE HOLDER

WARNING

Improper stack up of hardware will cause excessive heat and fuse failure. Stack up as shown.

FUSE HOLDER

Contents

Page www.xantrex.com Introduction Troubleshooting Things You Should Know Glossary Warranty 1.DC to AC power inverting 2.Automatic transfer switching between inverter power and incoming AC power 3.Automatic three-stagebattery charging plus manual battery equalizing Electronic Protection Circuit Breaker Protection Thermostat Controlled Cooling Inverter Idle Circuit Low and High Battery Shutdown Power Sharing Temperature Sensitive Charging (TSC) External AC Power Front Panel Controls and Indicators INVERT MODE CHARGE MODE •Turn the charger ON and OFF STATUS LEDs Battery Type Selection Operation Status INVERT CHARGE LOW BATTERY & OVERTEMP/OVERLOAD TSC (Temperature Sensitive Charging) OPTIONAL REMOTES not Remote Control Panel Page Series Parallel AMP-HOURCONSUMPTION FORMULAS (AC amps x 10) x 1.1 x hours of operation = DC amp hours (watts/ DC voltage) x 1.1 x hours of operation = DC amp hours (AC VA/ DC voltage) x 1.1 x hours of operation = DC amp hours Typical Power Consumptlon Fleet Power Battery Chargers The battery charger stages are: Stage 1 Bulk Charge Stage Stage Stage 4 Removal of residual sulfate 2.Bring all cells to the same potential Mixing up of the electrolyte 1.Do not equalize gel cell batteries. Check remote default settings Always monitor the equalize charge cycle 3.Check the battery electrolyte both With the Remote Control Panel Page Page Page Do not backfeed the AC output of the in- verter with incoming AC power Always use proper wire and connectors make sure these do not operate from the inverter output AC power When using a Remote Control Panel, the jumper is not used Grounding Neutral Bonding AC Wiring AC Input: AC Output: Dual AC Output Ground Fault Circult Interrupters Pass & Seymour Catalog Number Rated: 15 Amps at 120 Volts AC Remote Control Wiring Page Battery Cable Fusing Recommended Fuse: UL Listed Class T JLLN not 1.Test the inverter function: 2.Test the transfer function: 3.Test the battery charger function: Page Page Alternating Current (AC) Ampere (amp, A) Amp hour (Amp-Hr Ah) GFCI (Ground Fault Circuit Interrupter) Ground LED (Light Emitting Diode) Indicator light NEC Negative Fleet Power Page Installation examples for the FP3000-12 Shorepower configurations: Inverter/charger configuration: FP3000-12DC Cable and Fuse General Guide Installation Option #1 Page Installation Option #2 Page Page What does this warranty cover What will Xantrex do How do you get service Disclaimer Product Return Material Authorization Policy Return Procedure If you are returning a product from outside of the USA or Canada If you are returning a product to a Xantrex Authorized Service Center (ASC)