RESET / INFO FUNCTIONS

The drawing below shows the Reset/Info Functions layout. To access these, press the SETUP BUTTON for ten seconds. The time is long to avoid unintentionally entering this mode. When the green LED begins to flash quickly (about three times per second) select the Advanced Function you wish by consulting this drawing. The display returns to the monitoring mode five seconds after the selected function button is released.

#LOW BAT/ # OL: The number of Inverter Low Battery shutdowns (since last reset) isdisplayedwithaminussign(negativenumber). ThenumberofInvertershutdowns(since last reset) from other causes are displayed with no sign (positive number). The display alternates at three-second intervals until the button is released.

SOFTWARE INFO: The revision number of the LINK 2000 software is displayed.

FLASH ALL LEDS & SEGMENTS: This display test continues until the button is released.

RESET TO FACTORY DEFAULTS: When this button is held down for five seconds, all of the values set up for the selected battery are reset to the factory values. A 0 (zero) should appear briefly in the display (watch closely). All historical data is lost! Normally

this would only be done if you are changing batteries.

IMPORTANT NOTE! During a RESET TO FACTORY DEFAULTS any changes to the inverter/charger setup are also reset to the factory values IF the INVERT or CHARGE LEDs are on.

IMPORTANT NOTE! Function F11 (Battery #2 used for control) is NOT reset during a RESET TO FACTORY DEFAULTS.

23