TABLE OF CONTENTS
One Page Summary of Features | Center |
Introduction and Special Notes | 3 |
Monitor Functions | |
Inverter and Charger Functions | 5 |
Status Line and Starting and Stopping Equalize | 6 |
Setup | 7 |
Inverter Setup | 8 |
Monitor Setup | 9 |
Functions Setup | |
Data Mode | 15 |
How to Use The Link 2000 Control Panel | |
Ideal Charge Curve | 18 |
Synchronizing to a Full Battery (Resetting Amp Hours to Zero) | 20 |
Rules for Changing the Charged Parameters | 21 |
Selection Rules | 22 |
Reset / Info Functions | 23 |
High Discharge Rates and Peukert's Equation | |
Typical Peukert's Exponents | |
Error Codes and Troubleshooting | |
Microprocessor Reset Procedure (Resetting to Factor Defaults) | |
Setup and Historical Data Summary | 32 |
Warranty | 33 |
Required Reading Prior to Installation | 36 |
Wire By Wire Instructions | 37 |
Specifications | 39 |
THIS MANUAL APPLIES TO LINK 2000 METERS WITH SERIAL NUMBERS ABOVE 8500
AND LINK
Notice of Copyright
Xantrex Link 2000 Inverter Controller and Dual Battery Monitor © October 2002 Xantrex International. All rights reserved.
Disclaimer
UNLESS SPECIFICALLY AGREED TO IN WRITING, XANTREX TECHNOLOGY INC. (“XANTREX”)
(a)MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION.
(b)ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSS OR DAMAGE, WHETHER DIRECT, INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE ENTIRELY AT THE USER’S RISK.
Date and Revision: October 2002, Revision 1 | Part Number: | |
Contact Information Web: www.xantrex.com | Email: CustomerService@xantrex.com | |
Phone:1800 670 0707 | ||
2