Xerox 721P88200 manual DFA support for DocuPrint IPS, Additional notes

INCORPORATING XEROX VALUE-ADDED FEATURES

DFA is supported on the DocuPrint 180 IPS, 4635 IPS, 96 MICR IPS, 4635 MICR IPS, 180 MICR, and 4890 IPS. Currently, DFA is not supported for the DocuPrint 4050 IPS, 4090 IPS, and 4850 IPS. This table provides additional notes for the DocuPrint IPS printers that support DFA functionality:

Table 5-2.	DFA support for DocuPrint IPS
DocuPrint	Additional notes
IPS
180 and 180	If a Roll Systems roll-to-cut sheet feeder is attached, no
MICR	input enablement kit is required. However, you can
	attach the feeder to the back of the feeder/stacker
	modules. This replaces the feeder in that module. The
	stacker is still functional.
	If a bypass transport is attached, you can have a
	maximum of three feeder/stacker modules only.
	Set Recovery and Sheet Recovery are supported.
4635 and	If a roll-to-cut sheet feeder is attached, you must also
4635 MICR	have an Input Enablement Kit. Also, you can have
	maximum of three feeder/stacker modules only.
	If a bypass transport is attached, you can have a
	maximum of three feeder/stacker modules only.
	Set Recovery and Sheet Recovery are supported.
4890	If a roll-to-cut sheet feeder is attached, paper tray 2 is
	used. Also, an Input Enablement Kit is not required.
	Set Recovery and Sheet Recovery are not supported.

Note: Note that the following functions are not supported by any

DocuPrint IPS printers:

•automatic restart of the printer after clearing a “full” condition of the finishing device

•the LCDS (Xerox data stream) equivalent of Segment Management.

Contact your Xerox Account Representative to determine which third-party feeding and finishing devices are supported for your DocuPrint IPS printing system.

5-18 DOCUPRINT IPS SOLUTIONS GUIDE