PHASER® 7300 COLOR PRINTER
Diagnosing Print Quality
Review the five test pages printed with this page: The pages consist of cyan, yellow, magenta, and black; and another page with all four colors. Use the information below to help solve your
Note: The examples shown are
Problem
Light Lines in One Color
Thin, light or white lines appear in only one color.
Dark Lines in One Color
Thin, dark lines appear in only one color when a light color is faded or blended with black.
Solution
1.Open the top cover.
a.Clean the four LED bars (a) using
the cleaning pad supplied with a each new toner cartridge.
b.Check the Imaging Unit and
Caution: Do not leave the top cover open for more than 10 minutes without covering the Imaging Unit as damage could result. Use the dark bag that came with the Imaging Unit or dark paper as a cover.
2.If the problem persists after cleaning the LED bars, do the following:
a.Check the toner for the problem color. Replace the toner if low.
b.Lift out the Imaging Unit, for the problem color, keeping the toner cartridge installed.
c. With the Imaging Unit in an upright position (to avoid toner spills), lift it high enough to visually inspect the shiny green surface underneath.
d.If the shiny green surface has scratches or damage that align with the defect of the print, replace the Imaging Unit.
Note: Some slight scratching is normal.
Caution: Do not touch the shiny green surface of the Imaging Unit. Set the Imaging Unit on a hard flat surface only as scratching or damage can occur causing more
Printing Is Too Light or Too Dark in All Colors
Page 1 of 3
1.Try a different Color Matching mode. From the printer's front panel Support Menu select Improve Print Quality?, then select
Note: The TekColor Correction set to Automatic provides the best results for most documents.
2.Adjust the light or darkness levels. From the printer's front panel Support Menu, select Improve Print Quality? then select Calibrate Colors Menu, then select Print Tutorial Page. Follow the procedure Lighten/Darken Colors.
