SquareFold Trimmer Module | Overview |
Trimmer options
The Trimmer options are found in the following areas:
•On the machine's UI
•From the print server on the Properties window for a selected network print job, and
•From the Properties window of a selected print job on your workstation
Tip
Booklets exiting/leaving the SquareFold Trimmer Module may contain trim remnants/scraps from the previously trimmed booklet. This is due to static electricity
The Trimmer feature can be switched on or off based on user preference. When the feature is switched on, you can adjust the trim setting in 0.1 mm/0.003 9 in. increments depending on your requirements for the finished booklet job.
Note
For the remainder of this section, only the machine's UI is shown. The descriptions given for the Trimmer options are applicable for both copy and network print jobs, and applies to any print server connected to the machine. To see the actual screens for each print server, go to the desired print server and follow the instructions given in the previous section entitled "Network print jobs."
1. Touch the left/right arrow buttons to decrease or increase |
the trimmer setting. Adjustments are made in 0.1 |
Booklet Trimming / Pressing | Cancel | Save |
|
|
|
mm/0.003 9 in. increments. | |
2. The trimmer setting is based on: | |
• | The number of sheets in the finished booklet, |
• | The finished booklet width size (such as 8.5 in./210 |
| mm or 5.5 in/149 mm), |
• | The media type (coated/uncoated, glossy, etc.), |
| and |
• | The media weight |
Trimming
Paper Supply...
Off
Tray 3
11 x 17" 
OnPlain
Cut to Size |
|
| |
195.8 | 213.8 | ||
2. |
|
|
|
| 0 | mm | |
1. 
Book Pressing
Off
On
Tip
Important!: You may have to experiment with various settings in order to determine the best settings for your particular job. Also, you may want to run one or more test prints/copies before running larger jobs in order to ensure the best possible booklet output.
Note
Trim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20 mm (0.787 in.) of edge material from the booklet. Adjustments less than 2 mm (0.078 in.) may produce poor trim quality, and adjustments greater 20 mm (0.078 in.) will result in no trimming to the booklet edge.
Choose the setting that best fits your needs for the booklet output.
User Guide | 11 |
