Xerox SquareFold Trimmer manual Fault Codes

SquareFold Trimmer Module Problem solving

Fault Codes

If a jam/fault occurs in the SquareFold Trimmer Module, the machine’s UI displays a jam/fault message. The following table provides a list of fault codes for the SquareFold Trimmer Module and a list of related finisher fault codes.

Tip

The top covers cannot be opened during normal operation or when the machine is idle. The covers can be opened only when an indicator is lit (refer to page 4) and a jam/fault occurs within the SquareFold Trimmer Module.

Fault code	Possible cause	Recommended solution
	Jam/fault with the SquareFold Trimmer 1.	Open the Top Left and Right Covers of the SquareFold
	Module	Trimmer Module.
	2.	Carefully remove all sheets and paper scraps from jam
		clearance areas.
	3.	Close the SquareFold Trimmer Module Top Left and Right
		Covers.

4.Check the Trimmer Waste Container:

•If full, empty the container and reinsert it into the SquareFold Trimmer Module.

•If the container is partially pulled out, push it completely in.

5.If necessary, follow any remaining instructions on the machine’s UI.

6.If fault persists, repeat Steps 1-5; if fault persists after that, call for service.

User Guide 17