Compaq 3200 manual Post Error Messages

I-1

Appendix I

POST Error Messages

The Smart Array 3200 Controller produces diagnostic error messages at reboot. Many of these Power-On Self-Test (POST) messages are self-explanatory and suggest corrective actions for troubleshooting. Detailed information and corrective actions are listed below.

NOTE: SCSI Port 1 refers to internal or external drives attached to the internal

Port 1 connector. SCSI Port 2 refers to external drives installed in a Compaq

ProLiant Storage System attached to the external Port 2 connector.

Table I-1

POST Error Messages

Code	Meaning	Recommended Action
1702	SCSI Cable Error Detected. System Halted.	This message indicates a termination or cabling
		problem with the system board integrated SCSI
		controller. Refer to cabling information in the
		Smart Array 3200 Controller Installation Guide.
1720	Slot x Drive Array - S.M.A.R.T. Hard Drive	The indicated drive has reported a S.M.A.R.T.
	Detects Imminent Failure SCSI:	predictive-failure condition. It may fail at some
	Port y: SCSI ID x.	time in the future. If this drive is part of a non-
		fault-tolerant configuration, back up all data
		before replacing the drive and restore all data
		afterwards. If this drive is part of a fault-tolerant
		configuration, do not replace this drive unless
		all other drives in the array are online. Press F1
		to resume.

continued

Compaq Smart Array 3200 Controller Reference Guide