Compaq 3200 manual I-6 POST Error Messages, POST Error Messages continued, CodeMeaning

I-6POST Error Messages

POST Error Messages continued

CodeMeaning

1769 Slot x Drive Array - Drive(s) disabled due to failure during expansion (possibly followed by one of the following additional details:)

1.Array Accelerator Removed or Failed; Expansion Progress Data Lost.

2.Expansion Progress Data Could Not Be Read From Array Accelerator.

3.Expansion Aborted due to Unrecoverable Drive Errors.

4.Expansion Aborted due to Array Accelerator Errors.

Press F1 to continue with logical drives disabled.

Press F2 to accept data loss and to re-enable logical drives.

Recommended Action

Data has been lost while expanding the array, the drives have been temporarily disabled. Press F2 to acknowledge the data loss and re- enable the logical drives. Restore data from backup. If the Array Accelerator has failed, replace the Array Accelerator board after the capacity expansion progress has terminated. never turn off the system and replace the Array Accelerator board if capacity expansion is in progress.

(RESUME = F1 OR F2 KEY)

1774 Slot x Drive Array - Obsolete data found in Array Accelerator. Data found in accelerator was older than data found on drives. Obsolete data has been discarded.

(RESUME = F1 KEY)

1775 Slot x Drive Array - ProLiant Storage System Not Responding SCSI Port (y): Check storage system power switch and cables. Turn the system power off while checking the ProLiant power and cable connections, then turn the system power back on to retry.

(RESUME = F1 KEY)

Data found in Array Accelerator is older than data found on drives, due to drives having been disconnected, used on another controller, and then reconnected. Press F1 to discard older data.

Turn off power to system. Check external ProLiant power switch. External drives must all be powered-up before or at the same time as the main system. Check cables. If retry does not help, try replacing the cable, ProLiant firmware, ProLiant backplane, or the Smart Array 3200 Controller.

continued