Compaq manual Figure G-2. Cabling configurations for Smart Array 3200 Controller

G-5

SMARTArray 3200; Show cabling as shown for both connections.

Port 1

or

Port 2

External VHDCI-to-Standard	OR	External VHDCI-to-Wide
SCSI ProLiant Storage systems		cable required for connection
		to ProLiant Storage systems.
		(Included with ProLiant Storage Systems)

SMARTArray 3200 with single connector
daughterboard; Use external and internal
addings shown.				To Internal
Port 1
or				Drives
Port 2
			68-Pin
		68-Pin
	Internal 68-pin ribbon cable added				OR
	for internal wide drives in ProSignia

and ProLiant servers

SMARTArray 3200 with dual connector daughterboard; Use internal cablings shown for both connections.

68-to-50 pin adapter required for non hot-plug Fast-SCSI hard drives (199618-001)

Figure G-2. Cabling configurations for Smart Array 3200 Controller

To upgrade, attach disk drives (internal to the server or external to ProLiant Storage Systems) to the same numbered ports as the original controller. If an array spans both SCSI ports of the old controller, it is necessary to connect internal drives and external ProLiant Storage Systems to the same numbered ports on the Smart Array 3200 Controller as they were on the original SMART or SMART-2 Controller. If these port connections are wrong, a system power-on (POST) message will advise you to reconnect to the correct ports. If both ports are connected to separate arrays, they may be connected to either port as long as the relative order of the drives in each array is maintained.

Compaq Smart Array 3200 Controller Reference Guide