Compaq 3200 manual G-2 Upgrading from the SMART-2 and SMART SCSI Array Controllers

G-2Upgrading from the SMART-2 and SMART SCSI Array Controllers

3.Upgrade your System ROM to the most current version using the Compaq System ROMPaq. The System ROM must be upgraded before installing the Smart Array 3200 Controller. Your Smart Array 3200 Controller option kit may include a diskette containing Systems ROMPaq. If so, use the diskette to upgrade the system ROM. Otherwise, Systems ROMPaq is distributed on the Compaq SmartStart and Support Software CD included in the Smart Array 3200 Controller option kit. Review Chapter 3 in this guide for specific instructions on running Systems ROMPaq.

4.Perform a normal shutdown and turn OFF the server.

5.It is important to understand the difference between SCSI cable connector layouts for the SMART Controller, SMART-2 controllers, and Smart Array 3200 Controllers. See Figures F-1 and F-2.

The SMART Controller has a 100-pin external connector on the mounting bracket that connects to the Y cable that separates into two

50-pin Fast-SCSI-2 connectors, Port 1 and Port 2. These port numbers should be labeled on the Y cable and can be connected to external drives in Compaq ProLiant Storage Systems or other external storage units. Port 1 is also available as an internal connector on the top edge of the controller for internal drive connections. Port 1 can be used either internally or externally, but not both at the same time. Note the existing cable connections and port numbers for your system before disconnecting any cables.

The SMART-2DH Controller has an external 68-pin Fast-Wide SCSI-2 connector on the mounting bracket for Port 2 only. There is an internal 68-pin Fast-Wide SCSI-2 connector at the top edge of the controller for Port 1. This port can be used for internal drives through a standard internal ribbon cable, or for external drives through a special internal/external cable (included) and a connector panel or slot connector bracket (included) at the back of the server. This enables Port 1 connections to external drives in Compaq ProLiant Storage Systems. There is no Y cable used with the SMART-2DH Controller.