Compaq 3200 manual IBM OS/2 WARP Server Family, Installing the Operating System Drivers

6-30Installing the Operating System Drivers

Updating the Compaq Insight

Manager Agents

If you are using Compaq Insight Manager, you will need to update the Insight Agents to support the new Smart Array 3200 Controller.

If you used SmartStart 4.22 or later to install the operating system on a new Smart Array 3200 Controller installation or to upgrade your driver in an existing installation, the agents were updated by SmartStart; you will not have to manually update the agents.

If you did not use SmartStart 4.22 or later as part of your Smart Array 3200 Controller installation, you must manually update the Insight Agents. The correct agents can be obtained from your local Compaq Reseller or authorized Compaq Service Provider. Refer to the documentation included with Compaq Insight Manager for the correct procedure for updating agents.

Installation of the Smart Array 3200 Controller is now complete. Reboot the server to begin using the array controller.

IBM OS/2 WARP Server Family

Use the instructions in this section to install the initial driver for a new Smart Array 3200 Controller installation or to upgrade the driver in an existing OS/2 server/Smart Array 3200 Controller system. If you use SmartStart to install OS/2 and drivers on a new server, you do not need to create the OS/2 SSD diskettes and you can skip this section.

Materials Needed

To create the OS/2 SSD diskettes, you will need:

■Compaq SmartStart and Support Software CD (supplied in the Smart Array 3200 Controller option kit)

■Two blank diskettes

■Access to a server or workstation with a bootable CD-ROM drive. This may be the system in which you are installing Smart Array 3200 Controller.