| CONNECTIONS |
1 Remove approximately 10 mm (3/8 in) of | ■ Connecting the banana plug |
(With the exception of Asia, Korea, U.K. and | |
insulation from the end of each speaker | Europe models) |
cable and twist the exposed wires of the | First, tighten the knob and then insert the banana plug into |
cable together to prevent short circuits. | the end of the corresponding terminal. |
10 mm (3/8 in) |
|
| Banana plug |
2Unscrew the knob.
Red: positive (+)
Black: negative
3Insert one bare wire into the hole in the side of each terminal.
Red: positive (+)
Black: negative
Notes
•One or two speaker sets can be connected to this unit. If you use only one speaker set, connect it to either the SPEAKERS A or B terminals.
•Use speakers with the specified impedance shown on the rear panel of this unit.
PREPARATION
4Tighten the knob to secure the wire.
Red: positive (+)
Black: negative
9
