■General Setting

The default settings are marked with “ * ”.

System

Screen Saver

You can set the screen saver to on/off.

When set to on, this Player will switch to screen saver mode if there is no operation for 3 minutes. After that, this Player will turn to standby mode when there is no operation for 27 minutes.

On*, Off

Disc Auto Playback

You can set Disc Auto Playback to on/off. When set to on, a disc will play back automatically after loading.

On*, Off

HDMI Control

You can set the Player to receive control signal from a TV/AV receiver compatible with the HDMI Control function via an HDMI cable (p. 14).

On, Off*

Using HDMI Control function

Using the HDMI Control function, you can interactively operate this Player with your TV (HDMI Control function supported).

When you connect this Player to the TV compatible with the HDMI Control function using an HDMI cable and set HDMI Control in the SETUP menu to on (p. 33), you can perform the function listed below.

•Automatic input select function

When you start playback of this Player, the input selector of the TV (and an AV receiver if this Player is connected to the TV via the AV receiver) is switched to this Player automatically. TV Power is turned on automatically depending on the TV.

•Automatic power off function

When you turn off the TV while this Player is in stop mode and the SETUP menu screen is not displayed, the power of this Player is also turned off automatically.

Notes

–HDMI Control function may not work properly depending on the TV.

–Functions other than ones shown above may work depending on the TV or AV receiver.

–In order to make the HDMI Control function available, set up settings for the HDMI Control function on ALL components (this Player, TV, and AV receiver). Certain operation may also be required.

–Each function may be set independently to activate/deactivate depending on the TV.

–Refer to the operation manuals supplied with the TV and/or AV receiver for details regarding setup.

–When set to on, power consumption during standby mode increases due to HDMI Control function.

SETUP menu

Network Control

Sets the control for devices, which are connected via Ethernet, to On/Off. This Player employs Yamaha Network Control protocol (YNC).

On, Off*

Notes

–When Network Control is enable, power consumption during standby mode increases due to network control function.

–When set to On, the system startup time is decreased.

Load Default

You can reset all settings of this Player to default setting except Security setting (p. 34). For details on default settings, see pages 30–37.

Upgrade

You can upgrade the software manually from USB Storage or Network. For details on software upgrade, refer to “Software upgrade” (p. 40).

Easy Setup

You can perform Easy Setup (p. 20).

Local Storage

You can display Local Storage information, format Local Storage, and select Front USB/Rear USB to save the BD- Live data.

To format (empty) the “BUDA” folder in the USB memory device, select Information and press ENTER when “Format” is focused on the screen.

Front USB, Rear USB*

Hint

–Local Storage is used as an auxiliary memory when Blu-ray Disc is played back.

3D Playback Message

You can turn on or off a warning message concerning 3D video playback that appears on the TV when this Player is turned on.

On*, Off

Language

OSD

You can select the language for On Screen Display which is the messages or menu displayed on the screen such as SETUP menu.

English, Français , Español , Deutsch , Italiano , Svenska ,

Nederlandse , ,

4

Settings

English

33 En