Using this unit
This section describes the basic projecting operation after installation and connection have been completed.
Detailed settings must be made for installation, screen, input signal and so on, by following the menu setting procedure described in the section starting on page 15.
■Turning on the power
Remove the lens cap before starting any operation of this unit.
1.Plug the supplied power cord into the AC inlet on the rear of this unit. Then plug the cord into the wall outlet.
indicator
Power switch AC inlet
2.Turn on the power switch of this unit. The 
indicator lights up in red in a few seconds.
3.Press the STANDBY/ON button, the 
indicator flashes in green and the lamp inside this unit lights up.
The 
indicator stops flashing and lights steadily after about 15 seconds and this unit is ready for projection.
indicator
(Flashing in green → lights steadily in green)
STANDBY/ON |
| INPUT |
| STANDBY/ON |
LAMP | TEMP | PATTERN | AUTO | PATTERN |
/COVER | /FAN | 24P |
|
|
PATT
ESCAPEMENU
SELECT
STANDBY/ON
ASPECTINPUT
RESET STILL HIDE
Important
•Never turn off the power switch or unplug this unit
while the 
indicator is lit or flashing in green. This causes significant damage to the lamp and may result in its shorter life or failure.
■Focusing
Press the PATTERN button to project the stored test pattern. Adjust the lens so that it comes into focus by rotating the focus ring. The image size can be also adjusted with the zoom ring.
PATTERN
|
| INPUT | ESCAPE |
R | TEMP | PATTERN | MENU |
/FAN | 24P |
|
Zoom ring
Focus ring
Lens
There are two test patterns. Choose whichever is desired by pressing the + or – button.
Press the PATTERN button again to close the test pattern.