◆TRIGGER terminal
The TRIGGER terminal on the rear of the projector is a terminal that outputs 12 V signal to control an externally connected equipment when images are projected.
To use the TRIGGER terminal, set TRIGGER OUT to ON in the SETUP menu. (The factory default is OFF.) Use the following steps to change the setting.
|
| COMPONENT |
| HDMI | Y PB/CB PR/CR |
AC IN | ||
| SERIAL | |
| USB | |
|
| TRIGGER |
|
| VIDEO |
To TRIGGER terminal
(See page 23 for menu setting.)
1.Display the SETUP menu.
2.Select TRIGGER OUT by pressing the 
or 
button.
3.Select ON by pressing the 
or 
button.
Ring (NC)
Tip (12 V)
Sleave (ground 0 V)
4.Press the MENU button several times.
•Do not use the signal output from the TRIGGER terminal as a power for other equipment.
•Do not link the TRIGGER terminal with an audio terminal of other equipment. This may cause a damage.
•The rated current for the TRIGGER terminal is 200 mA. If you use a current exceeding this rating, a failure may occur.
•For information about electric screens, please contact screen manufacturers.
◆Plugging in the power cable
| For US | For Europe |
|
|
| Earthing |
AC IN | HDMI | terminal | |
| SERIAL | USB |
|
|
|
| TRIGGER |
|
|
| 2 |
| 1 |
| Power cable |
1.Plug the supplied power cable into the AC IN of this projector.
2.Plug the other end of the power cable into a power outlet.
AC IN | HDMI |
SERIAL USB
TRIGGER
1
Earthing terminal
2
Power cable
•The power cables for use in the U.S. and Europe are included with this projector. Use the appropriate one for your country.
•This projector uses the power plug of
•The provided power cable for the U.S. is rated at 120 V. Never connect this cable to any outlet or power supply using other voltages or frequencies than rated. If you use a power supply using other voltage than rated, prepare an appropriate power cable separately.
15