Adjusting delay time
You can adjust the time difference between the beginning of the sound from the main speakers and the beginning of the effect sound from the rear speakers.
The larger the value, the later the effect sound is generated. This adjustment can be made to all programs individually.
Notes
•Adding too much delay will cause an unnatural effect with some sources.
•When + or
| Program | Control range (ms) | Preset value |
| |
|
|
|
|
|
|
| 1. | DOLBY PRO LOGIC | 15 to 30 | 20 |
|
|
| DOLBY DIGITAL | 0 to 15 | 5 |
|
| 2. | DOLBY PRO LOGIC ENHANCED | 15 to 30 | 20 |
|
|
| DOLBY DIGITAL ENHANCED | 0 to 15 | 5 |
|
| 3. | 70 mm MOVIE THEATER | 15 to 30 | 20 |
|
|
| DIGITAL MOVIE THEATER | 1 to 99 | 16 |
|
| 4. | MONO MOVIE | 1 to 99 | 49 |
|
| 5. | TV SPORTS | 1 to 99 | 9 |
|
| 6. | DISCO | 1 to 99 | 40 |
|
| 7. | ROCK CONCERT | 1 to 99 | 16 |
|
| 8. | CONCERT HALL | 1 to 99 | 44 |
|
|
|
|
|
|
|
|
|
|
|
|
|
Adjusting output level of the center, right rear and left rear speakers, and subwoofer
If desired, you can adjust the sound output level of each speaker even if the output level is already set in “SPEAKER BALANCE ADJUSTMENT” on pages 21 to 23.
Notes
•Output level of the center speaker cannot be adjusted when the program DISCO, ROCK CONCERT or CONCERT HALL is selected, and the input signal is analog, PCM audio, or encoded with Dolby Digital in
•If the function “1. CNTR” in the SET MENU mode is set to the NONE position, the sound output level of the center speaker cannot be adjusted. This is because, in this mode, the center sound is automatically output from the left and right main speakers.
•Once the output level is adjusted, the level will be the same for all digital sound field programs.
| Speakers | Control range (dB) | Preset value |
|
|
|
|
|
|
| CENTER | MIN, | 0 |
|
| RIGHT SURROUND (Rear) | MIN, | 0 |
|
| LEFT SURROUND (Rear) | MIN, | 0 |
|
| SUBWOOFER | MIN, | 0 |
|
|
|
|
|
|
|
|
|
|
|
Note
The values of the delay time, center/rear/subwoofer output level you set the last time will remain memorized even when this unit is in the standby mode. However, if the power cord is kept disconnected for more than one week, these values will automatically change back to the original factory settings.
34
34 | 3/25/99, 3:54 PM |