Yamaha DSP-AX757SE owner manual Setting remote control codes, Remote Control Code Default Settings

Setting remote control codes

You can control other components by setting the appropriate manufacturer codes. Codes can be set up for each input area.

The following table shows the factory preset component (Library: component category) and the remote control code for each area.

Remote Control Code Default Settings

	Component
Input area	category	Manufacturer
	(Library)
A	LD	Yamaha
B	CD-R	Yamaha
PHONO	TV	–
V-AUX	VCR	–
TUNER	TUNER	Yamaha-3
MD/CD-R	MD	Yamaha-1
CD	CD	Yamaha-1
DTV/CBL	TV	–
VCR 1	VCR	–
DVR/VCR2	DVR	Yamaha
DVD	DVD	Yamaha-1

Note

You may not be able to operate your YAMAHA component even if a YAMAHA remote control code is initially set as listed above. In this case, try to set other YAMAHA remote control code(s).

1Press an input selector button to select the source component you want to set up.

REMOTE CONTROL FEATURES

2Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object.

“SETUP” and the selected component name appear alternately in the display window.

LEARN

Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start.

y

Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again.

If you want to change a library (component category), press j / i. You can set a different type of component.

Library choices: L:DVD, L:DVR, L:LD, L:CD, L:CDR, L:MD, L:TAP (tape), L:TUN, L:AMP*, L:TV, L:CAB (cable), L:DBS, L:SAT, L:VCR

*The amplifier Library (L:AMP) code is preset to “ID1” to operate this unit. However, you can switch between the following two codes if necessary.

The initial setting for “Amplifier library” is “ID1”.

AMP library		Remote
code		control ID
(remote	Function	(this unit’s
control		setting: see
setting)		page 67)
ID1	To operate this unit using the
(initial setting)	default code.
ID1Z	To operate this unit using the	ID1
	default code.	(initial
	To operate Zone 2 or Zone 3	setting)
	features (see page 76).
	(RX-V757 only)
ID2	To operate this unit using an
	alternative code.
	To operate this unit using an	ID2
	alternative code.
ID2Z	To operate Zone 2 or Zone 3
	features (see page 76).
	(RX-V757 only)

When using multiple YAMAHA receivers/amplifiers, you may be able to operate the other components simultaneously with the default code setting. In this case, set one of the alternative codes to operate this unit separately

OPERATION ADVANCED

English

69