Troubleshooting
If there is any problem with your CinemaStation system, check the following items. If you cannot solve your problem with the following remedies or if your problem is not listed below, turn off and unplug the CinemaStation, then consult the nearest authorized YAMAHA dealer or service center.
General
Problem | Cause | Solution |
Power turns on but | The system cable may be connected | Make sure the system cable is |
immediately shuts off | improperly. | connected properly. (page 10) |
|
|
|
| The power cable may be connected | Make sure the power cable is plugged |
| improperly. | into the outlet firmly. (page 17) |
|
|
|
| The speaker cable may be shorted. | Make sure all speaker cables are |
|
| connected properly. (page 10) |
|
|
|
| The CinemaStation may receive a | Set the CinemaStation to the Standby |
| strong electrical shock such as from a | mode, then disconnect the power cable. |
| lightening bolt or excessive static | Wait for about 30 seconds, then connect |
| electricity. | the power cable and turn on the |
|
| CinemaStation. |
|
|
|
The speakers make no | The volume may be set to minimum | Adjust the volume level. (page 20) |
sound | level. |
|
|
|
|
| The Mute function may be enabled. | Cancel the Mute function. (page 20) |
|
|
|
| The input source or input setting may | Select the correct input source or input |
| be incorrect. | |
|
|
|
| The cables may be connected | Make sure all cables are connected |
| improperly. | properly. (page 9) |
|
|
|
| The disc loaded into the | Make sure you use a disc supported by |
| CinemaStation may be not | the CinemaStation. (page 32) |
| compatible. |
|
|
|
|
| You are playing a DTS source and | Select “All” for “Digital output” in the |
| “PCM Only” is selected for “Digital | |
| output” in the |
|
|
|
|
The TV shows no picture | The cables may be connected | Make sure all cables are connected |
| improperly. | properly. (page 12) |
|
|
|
Sound suddenly turns off | The Sleep Timer (page 28) might be | Turn on the CinemaStation and play the |
| set. | source again. |
|
|
|
Sound is too low on one | The cables may be connected | Make sure all cables are connected |
side | improperly. | properly. (page 9) |
|
|
|
Speakers other than the | You may be listening to stereo | Press STEREO to enable the sound |
front ones make no sound | sounds without the sound field effect. | field effect. (page 63) |
|
|
|
| You may be listening to an audio | Select another DSP program. (page 26) |
| source (Dolby Digital or DTS) that |
|
| does not contain any special effect |
|
| signal. |
|
|
|
|
80