Quick Start Guide
11
Quick Start Guide
Once that you’ve got the DX200 out of the box and checked that all included items were indeed included, it’s
time to set everything up and get playing.
1 Turn the VOLUME control all the way down to the minimum.
2 Connect the OUTPUT jacks (L/MONO and R) to the inputs of your
recorder/mixer/amplifier.
If you’re using a mono system, use only the L/MONO jack. If you’re using headphones, connect them to
the PHONES jack.
3 Plug in the included power adaptor — first, one end into the DC IN termi-
nal, then the other into an AC outlet.
4 Turn on the power with the rear panel power switch. Then, turn on the
power of your recorder/mixer/amplifier.
The DX200 takes a little time to “warm up” after being turned on – roughly 15 seconds. After
the startup routine is finished, your DX200 is ready to play.
5 Press the Start/Stop button on the DX200 to start a Pattern and slowly
turn up the VOLUME control until the level is appropriate.
To stop the Pattern, simply press the Start/Stop button again.
And that’s all there is to it. Now go on to the Tips and start playing!
Headphones
Amplifer
Mixer
Recorder
or
AC
Adaptor
DX200 DC IN OUTPUT
PHONES
or
AC outlet