Yamaha HTR-5760 Starting the setup, Auto Menu, Result Wiring, 2Press AMP, 3Press SET MENU

AUTO SETUP

Starting the setup

For best results, make sure the room is as quiet as possible during the auto setup procedure (YPAO). If there is too much ambient noise, the results may not be satisfactory.

y

If your subwoofer has adjustable volume and crossover/high cut frequency controls, set the volume between 9 and 11 o’clock (as viewed on a conventional clockface) and set the crossover/high cut frequency to the maximum.

VOLUME		CROSSOVER/
		HIGH CUT
MIN	MAX	MIN	MAX

Subwoofer

1Switch on this unit and your video monitor.

Make sure the OSD is displayed.

2Press AMP.

AMP

3Press SET MENU.

SET MENU

MENU

A/B/C/D/E

4Press u / d to select AUTO SETUP.

PRESET/CH	SET MENU
	. ;AUTO
SELECT	;MANUAL
	]/[p ]:Up/Down

6Press u / dto select SETUP, then press j / i to select the desired setting.

1 AUTO:MENU

. SETUP;;;;;;;AUTO START

all items [p]/[p]:Up/Down [<]/[>]:Select

AUTO To perform the auto setup procedure (YPAO).

RELOAD To reload the last auto setup (YPAO) settings to override any manual changes.

UNDO To undo the last auto setup (YPAO) and restore the previous settings.

DEFAULT To restore the factory preset (default) setup parameters.

y

You can choose RELOAD or UNDO only if you have already performed auto setup.

7Press dto select START, then press SELECT to start the setup procedure.

•If you selected AUTO in step 6, loud test tones will be output from each speaker in turn; WAIT appears during the auto setup procedure.

•If you selected DEFAULT, RELOAD or UNDO in step 6, no test tones are output.

1 AUTO:MENU

;;;;;;;AUTO

.

p p

5Press SELECT to enter AUTO SETUP.

PRESET/CH

SELECT

The RESULT:WIRING screen appears after all items have been measured and set.

RESULT:WIRING

FRONT L;;;;;;;OK

[<]/[>]:Select

[SELECT]:Return

•If an ERROR screen appears, see “If an error screen appears” on page 27.

•If a WARNING screen appears, see “If a warning screen appears” on page 28.

26