Yamaha HTR-5760 owner manual IMPEDANCE SELECTOR switch, U.S.A. model

CONNECTIONS

■IMPEDANCE SELECTOR switch

(U.S.A. model)

CAUTION

Do not change the setting of the IMPEDANCE SELECTOR switch when the unit power is switched on, as doing so may damage the unit.

If this unit fails to turn on when STANDBY/ON is pressed on either the front panel or remote control, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If this is the case, slide the switch all the way to either position when this unit is in standby mode.

Select the switch position (left or right) according to the impedance of the speakers in your system.

				SET BEFORE POWER ON
				IMPEDANCE SELECTOR
			IMPEDANCE SELECTOR switch
Switch position	Speaker		Impedance level
		If you use one set (A or B), the impedance of each speaker must be
		4 Ω or higher.
	Front
Left		If you use two sets (A and B), the impedance of each speaker must be
		8 Ω or higher.
	Center, Surround, Surround back,	The impedance of each speaker must be 6 Ω or higher.
	Presence
		If you use one set (A or B), the impedance of each speaker must be
		8 Ω or higher.
	Front
Right		If you use two sets (A and B), the impedance of each speaker must be
		16	Ω or higher.*
	Center, Surround, Surround back,	The impedance of each speaker must be 8 Ω or higher.
	Presence

*The Canada model cannot use two separate speaker systems (A and B) simultaneously when the switch is set to the right position.

PREPARATION

English

23