
Adjustments
Wing Deck Position Switches
Adjustment
1.Park machine on a level surface, lower cutting deck, stop engine, engage parking brake and remove key from the ignition switch.
2.Remove switch cover from deck to allow access to position switch that requires adjustment.
NOTE: Use Deck Proximity Switch Adjustment Tool (TOR4095) to assist with switch adjustment (see Spe- cial Tools).
3.Loosen two (2) lock nuts that secure switch bracket to center cutting deck (Fig. 7).
4.When adjusting switch location, the target surface of position switch should be approximately 0.188” (4.8 mm) from actuator tab on wing deck link (Fig. 8).
5.When wing deck position switch is properly adjusted, hydraulic motor on wing deck should turn off when wing deck is raised and wing deck latch opens.
6.For switch testing information, see Wing Deck Posi- tion Switches in the Component Testing section of this chapter.
| 5 |
| 4 |
| 3 |
| 2 |
6 |
|
7 | 1 |
|
Figure 7
1. | Position switch | 5. | Carriage screw (2 used) |
|
2. | Lock nut (2 used) | 6. | Center cutting deck |
|
3. | Flat washer (2 used) | 7. | Screw (2 used) | Electrical System |
4. | Switch bracket |
|
| |
| 1 |
| 0.188” | |
|
|
|
| |
|
|
| (4.8 mm) |
|
2
3
|
| Figure 8 |
1. | Position switch | 3. Wing deck link |
2. | Actuator tab |
|
Groundsmaster | Page 5 | Electrical System |