Toro 4100-D service manual Bevel Gear Case and Axle Case Installation

Bevel Gear Case and Axle Case Installation

1.Coat new shaft seal with grease and install in axle case as shown (Fig. 20).

3

2

1

		Figure 20
1.	Axle case	3. Shaft seal
2.	Bevel gear case

2.Install the lower bevel gear and bevel gear shaft in the axle case cover. Coat a new O-ring with grease and install the axle case cover (Fig. 21). Tighten cover screws from 17 to 20 ft-lb (23 to 27 N--m).

3.Slide the bevel gear case over the bevel gear shaft and install the bevel gear and collar. Make sure the bevel gear shaft is completely seated in the upper and lower bearings (Fig. 21).

4.Install the knuckle pin. Use medium strength Loctite thread locker and tighten the knuckle pin mounting screws from 17 to 20 ft-lb (23 to 27 N--m).

7

8

6

5

3

2

1

4

Figure 21

1.	Axle case cover	5.	Upper bevel gear
2.	Lower bevel gear	6.	Collar
3.	Bevel gear shaft	7.	Upper bearing
4.	Lower bearing	8.	Knuckle pin

Axles, Planetaries and Brakes

Groundsmaster 4100--D Page 6 -- 19 Axles, Planetaries and Brakes