![](/images/new-backgrounds/1093955/93955257x1.webp)
Removal (Fig. 64)
1.Park machine on a level surface, lower cutting deck, stop engine, engage parking brake and remove key from the ignition switch.
2.Read the General Precautions for Removing and Installing Hydraulic System Components at the begin- ning of this section.
3.To prevent contamination of hydraulic system during steering valve removal, thoroughly clean exterior of steering valve and fittings.
4.Remove steering valve from machine using Figure
64as a guide.
5.If hydraulic fittings are to be removed from steering valve, mark fitting orientation to allow correct assembly. Remove fittings from valve and discard
Installation (Fig. 64)
1.If fittings were removed from steering valve, lubricate and place new
2.Install steering valve using Figure 64 as a guide.
3.Make sure hydraulic tank is full. Add correct oil if nec- essary before returning machine to service.
System
Hydraulic
Groundsmaster | Page 4 | Hydraulic System |