Toro 4100-D service manual Bevel Gear Case and Axle Case Removal

Bevel Gear Case and Axle Case

The following procedures assume the rear axle assem- bly has been removed from the machine (see Rear Axle Assembly Removal in this section).

35 to 41 ft-lb

(47 to 56 N-m)

Bevel Gear Case and Axle Case Removal

1.	Remove the mounting screws, nuts and lock wash-
ers. Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 15).
2.	Mark both right and left bevel gear case/axle case

4

1

2

3

6 5

assemblies.

IMPORTANT: Do not interchange right and left bev- el gear case/axle case assemblies.

35to 41 ft-lb

(47 to 56 N-m)

Figure 15

1.	Cap screw (4 used)	5.	Bevel gear case/axle
2.	Lock nut (2 used)	case assembly
3.	Lock washer (2 used)	6.	O-ring
4.	Axle support

3.Remove the axle cover mounting screws. Remove the axle cover from the axle case as an assembly (Fig. 16).

1

2

Figure 16

17 to 20 ft-lb

(23 to 27 N-m)

4

3

Planetaries Brakes

4.Remove the axle case support mounting screws, the axle case support and the support shims (Fig. 17).

1.	Axle case	3.	Mounting screw (6 used)
2.	Axle cover assembly	4.	O-ring

Threadlocking

Compound3

257 to 67 ft-lb

(77 to 91 N-m)

4

1

Axles, and

Figure 17

1.	Axle case	3.	Mounting screw (2 used)
2.	Axle case support	4.	Support shim

Groundsmaster 4100--D Page 6 -- 17 Axles, Planetaries and Brakes