Toro 4100-D service manual Specifications, Cutting Deck Groundsmaster 4100--D

Specifications

MOUNTING: Cutting deck is supported by lift arms con- trolled with hydraulic lift levers.

CONSTRUCTION: Deck chamber is welded 12 gauge steel construction reinforced with channels and plates.

HEIGHT--OF--CUT RANGE: 1” to 5” (25.4 mm to 127

mm)adjustable in 1/2” (12.7 mm) increments. Center deck height--of--cut adjustment is achieved by changing spacers on castor wheels and adjusting length of deck support chains. Wing deck adjustment achieved by changing spacers on castor wheels, re--positioning the castor wheel axles in the castor forks and securing the castor wheel bracket to the correct height--of--cut brack- et holes.

DECK DRIVE: Closed loop hydraulic system operates hydraulic motor on each cutting deck section. Motor drives one spindle directly with remaining deck section spindle(s) driven by B section kevlar v--belt(s). Blade spindles are 1--1/4” (31.7 mm) shafts supported by greaseable, tapered roller bearings.

CUTTING BLADE: Cutting blade dimensions are 19” (483 mm) long, 2.5” (64 mm) wide and 0.250” (6.4 mm) thick. Anti--scalp cup installed on each cutting blade. Center deck includes three blades and each wing deck includes two blades.

WIDTH OF CUT: Front deck provides 54” (1372 mm) width of cut. Each side deck has 37” (940 mm) width of cut. Total width of cut is 124” (3150 mm).

DISCHARGE: Clippings are discharged from the rear of the cutting deck.

SUSPENSION SYSTEM: A fully floating suspension with hydraulic counterbalance. Front deck suspended from lift arms and has six castor wheels, two adjustable skids and five anti--scalp rollers.

Cutting Deck Page 8 -- 2 Groundsmaster 4100--D