Toro 4100-D service manual Steering stop bolt Bevel gear case LH

8.Install steering cylinder to axle assembly (see Steer- ing Cylinder Installation in the Service and Repairs sec- tion of Chapter 4 -- Hydraulic System).

9.Install hydraulic motor to axle assembly (see Rear Axle Motor Installation in the Service and Repairs sec- tion of Chapter 4 -- Hydraulic System).

10.Install wheels to axle.

WARNING

Failure to maintain proper wheel lug nut torque could result in failure or loss of wheel and may re- sult in personal injury.

11.Lower machine to ground. Torque wheel lug nuts from 85 to 100 ft--lb (115 to 135 N--m).

12.Fill axle and input gearbox with SAE 85W--140 weight gear lube. Lubricant capacity is approximately 80 fl. oz. (2.37 liters) for the axle and 16 fl. oz. (0.47 liters) for the gearbox.

13.Check rear wheel toe--in and adjust if necessary.

14.Check steering stop bolt adjustment. When the steering cylinder is fully extended (right turn), a gap of 1/16” (1.6 mm) should exist between bevel gear case casting and stop bolt on left axle case. Figure 14 shows stop bolt location.

2

1

	Figure 14
1. Steering stop bolt	2. Bevel gear case (LH)

Axles, Planetaries and Brakes Page 6 -- 16 Groundsmaster 4100--D