Toro 4100-D service manual Wing Deck Service

Wing Deck Service

					160 to 180 ft--lb									30 to 40 ft--lb
			25	(217 to 244 N--m)										(41 to 54 N--m)
2
												46
									45
				43			23
3
						34	40							47
													48
													3749		51
													31	30
1											41				28
				24			27	35	32 10			42
4							26
				24			23
							3936
5	6	44	33	19											29
		7
				39
				21	22	20 19									38
										11
		50					18
RIGHT							52					17	14
		54					53					16		15
FRONT							8
							52
							9			17	13
							10		12

Figure 6

1.	Wing deck (RH shown)	19.	Flange nut (front links)	37.	Tapered stud
2.	Skid (RH shown)	20.	Grease fitting	38.	Hose guide
3.	Flange screw (2 used per skid)	21.	Link assembly (4 used)	39.	Hardened spacer (0.120” thick)
4.	Flange nut (2 used per skid)	22.	Cap screw (front links)	40.	Plug
5.	Cap screw	23.	Thrust washer (0.030” thick)	41.	Grease fitting
6.	Roller (2 used)	24.	Flat washer (4 used)	42.	Foam washer (4 used)
7.	Lock nut	25.	Lock nut (4 used)	43.	Link skid (2 used)
8.	Pivot latch (2 used)	26.	Carriage bolt (4 used)	44.	Link skid (2 used)
9.	Flat washer	27.	Latch pin	45.	Flat washer
10.	Retaining ring (2 used per latch)	28.	Flat washer (2 used)	46.	Flange nut
11.	Cap screw (3 used per latch)	29.	Cap screw (4 used)	47.	Dust cap
12.	Lock nut (3 used per latch)	30.	Cap screw (rear links)	48.	Retaining ring
13.	Spring support	31.	Hex jam nut (rear links)	49.	Spherical bearing
14.	Compression spring	32.	Washer head screw (12 used)	50.	Switch shield (RH shown)
15.	Lug nut	33.	Wing strap (2 used)	51.	Center deck
16.	Lock roller (2 used per latch)	34.	Flex shield (2 used)	52.	Flange bushing
17.	Bushing (3 used per latch)	35.	Shield strap (center deck)	53.	Grease fitting
18.	Pivot pin (4 used)	36.	Switch tab (front links)	54.	Washer head screw (2 per shield)

Cutting Deck Page 8 -- 10 Groundsmaster 4100--D