Toro 4100-D service manual Cutting Deck Lift Arms, Removal Fig

Cutting Deck Lift Arms

								8
									60 to 70 ft-lb
			38					9	(81 to 94 N-m)
	Loctite 242	10
	on threads
		11
	30 to 40 ft-lb		12		3	2			7
RIGHT	(41 to 54 N-m)			13
		15	14			1
	16					11			6
FRONT		17
		18						4	5
							36
		19
	20	21
		22					35
	23			33		16	34
							25
	24					32		155 to 185 ft-lb
		16						(211 to 251 N-m)
	25			27	30	31
		26			29
				28		16
						37		75 to 85 ft-lb
								(102 to 115 N-m)

Figure 2

1.	Lift cylinder	14.	Flange nut	27.	Clevis pin
2.	Clevis pin	15.	Lock nut	28.	Hair pin
3.	Cap screw	16.	Flat washer	29.	Flat washer
4.	Grease fitting	17.	Grease fitting	30.	Flange nut
5.	Lift arm pin	18.	Flange head screw	31.	Height-of-cut chain
6.	Slotted roll pin	19.	Lift cylinder pin	32.	U-bolt
7.	Lock nut	20.	Flange nut	33.	Nut
8.	Cotter pin	21.	Spherical bearing	34.	Lock nut
9.	Pivot pin	22.	Tapered stud	35.	Flange bushing (2 per lift arm)
10.	Hair pin	23.	Retaining ring	36.	Lift arm (LH)
11.	Spherical rod end	24.	Cap screw	37.	Lock nut
12.	Damper	25.	Grease fitting	38.	Lift arm (RH)
13.	Yoke spacer	26.	Support hub

Removal (Fig. 2)

1.Park machine on a level surface, lower cutting deck, stop engine, engage parking brake and remove key from the ignition switch.

2.Remove front cutting deck (see Cutting Deck Re- moval in Chapter 8 -- Cutting Deck).

Chassis Page 7 -- 4 Groundsmaster 4100--D