Wing Deck Latch
Disassembly (Fig. 12)
1.Raise wing deck to transport position. Carefully ro- tate latch to closed position.
2.Loosen lug nut to release compression spring ten- sion.
3.Remove retaining ring and flat washer from bottom of latch pin. Rotate lug nut enough to allow latch pin to be removed from latch.
4.Remove lug nut from spring support. Remove latch assembly from deck.
5.Disassemble latch (items 1 through 8) using Figure
12as a guide.
Assembly (Fig. 12)
1.Assemble latch (items 1 through 8) using Figure 12 as a guide.
2.Slide spring onto spring support and insert end of spring support into hole located on underside of center deck. Start lug nut (tapered side towards plate on deck) onto spring support.
3.Tighten lug nut until holes in front of deck align with bushings in latch. Insert latch pin with retaining ring down through deck and latch. Secure latch pin on under- side of deck with flat washer and retaining ring.
4.Carefully rotate latch to the open position. Lower wing deck to allow link to engage latch.
5.Lubricate latch grease fitting.
9 |
|
|
|
|
|
|
13 |
|
|
|
|
|
|
14 |
|
|
|
|
|
|
5 |
|
|
|
|
|
|
4 |
|
|
|
|
|
|
3 |
|
|
| 6 |
|
|
|
|
|
| 4 |
| |
|
|
|
| 3 | 12 | |
2 |
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
|
| |
1 |
|
|
|
|
|
|
5 |
|
|
|
|
|
|
10 | 9 | 8 | 4 | 7 |
| 11 |
|
|
|
Figure 12
1. | Latch | 8. | Lock nut (3 used) |
2. | Grease fitting | 9. | Retaining ring |
3. | Lock roller | 10. | Flat washer |
4. | Bushing | 11. | Compression spring |
5. | Flange bushing | 12. | Lug nut |
6. | Cap screw (3 used) | 13. | Latch pin |
7. | Spring support | 14. | Center deck |
Cutting Deck | Page 8 | Groundsmaster |
