Connections
Connecting the FM and AM antennas
Both FM and AM indoor antennas are supplied with this unit. Connect each antenna correctly to the designated terminals. In general, these antennas should provide sufficient signal strength.
y
See page 8 for connection information of the supplied indoor FM antenna and AM loop antenna.
Notes
•The AM loop antenna should be placed away from this unit.
•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas.
Indoor FM | AM loop |
antenna | antenna |
(supplied) | (supplied) |
Connecting the power cable
To the AC wall outlet
AC OUTLETS |
■AC OUTLETS (SWITCHED)
Use these 2 outlets to supply power to any connected components. Connect the power cable of your other components to these 2 outlets. Power to these 2 outlets is supplied when this unit is turned on. However, power to
|
| ANTENNA |
75 | FM | GND AM |
UNBAL. |
|
Ground (GND terminal)
Outdoor AM antenna
Use a 5 to 10 m (16 to 33 ft)
these 2 outlets is cut off when this unit is turned off. For information on the maximum power or the total power consumption of the components that can be connected to these 2 outlets, see “Specifications” on page 106.
Note
The power to AC OUTLETS of this unit is not cut off while this unit is charging connected iPod even when this unit is in the standby mode. When this unit completes charging or the iPod is disconnected, the power is cut off automatically when this unit is in the standby mode.
Memory back-up
For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.
The memory
