Troubleshooting (in operation)
NUAGE FADER Operation Manual 25
Troubleshooting (in operation)

A connection cannot be

established with Pro Tools.

• Ensure that the steps described in “Settings for Pro
Tools” (page26) have been completed.

The [Fader] motors do not operate.

• Ensure that the [Fader] motors are turned on. To do so,
check the settings from “Motor” (page23) in NUAGE
FADER Se tup.

The [Channel name displays] turn

off unexpectedly.

• The [Channel name displays] turn off automatically after
a certain period of inactivity in order to protect them.
You can set this period using “OLED Off Time”
(page 23) in NUAGE FADER Setup.

[REC] from the CHANNEL STRIP

section cannot be turned on.

• “Input Routing” must be set in order to turn on [REC] for
“Audio” channels.

The [Faders] do not move in

response to channel scrolling

using the [Touch slider bar].

• The function allowing the [Faders] to reflect [Touch
slider bar] actions is turned off. Turn on “Follow Slider
Scroll” (page 23) in NUAGE FADER Setup.
Appendix

Contents of the Getting

Started Manual

PRECAUTIONS
NOTICE
Information
Introduction
A Message from the Development Team
Included Accessories
Items to Have Ready
How to Read the Manual
Setup
Overall Process
Setting and Connecting
Setting up the Power Supply
Installing TOOLS for NUAGE
Configuring the Workgroup on NUAGE
Troubleshooting (in setting up)
Appendix
Contents of the Operation Manual
Firmware Updates
Adjusting the Touch Sensitivity
Specifying the Brightness
Calibrating Fader Motion or Position
Resetting to the Factory Default Condition
Dimensions
Specifications

Replacing Square-button

Labels

The labels from the square buttons can easily be
replaced. These replacements can be made by cutting a
transparent or semi-transparent sheet into 10 x 10 mm
pieces. To install, simply remove the button’s cap, swap
out the current label, and replace the cap.