Yamaha PDM-4210E OPERATING INSTRUCTIONS continued, Size Switching, Input Signal Screen Display

OPERATING INSTRUCTIONS (continued)

RGB 1	RGB 2	MUTE	VOL
AV1	AV2	AV3	AV4
AUTO	PinP	SIZE	RECALL
			RECALL button
MENU
		OK
SIZE button
ID			ID SET

RECALL button

SIZE button

Size Switching

Each time the SIZE button of the remote control or the monitor is pressed, the screen display area will change in sequence and the status will be displayed at the bottom of the screen.

Normal Full Zoom1

Real* Zoom3 Zoom2

*Real mode gives an image of the same shape as it is displayed on a computer monitor. This mode is only available for VGA (640 X 480) and WVGA (864 X 480).

Display area selection diagram (RGB input)

Resolution	Full display			Circular display
Display	Full	Normal	Real	Zoom1	Zoom2	Zoom3
640 X 480
(VGA)
800 X 600
(SVGA)
1024 X 768
(XGA)
1280 X 1024
(SXGA)
1600 X 1200			* VGA and W-VGA
(UXGA)			only

Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On 20 can reduce the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.

•The display will go out in approximately 6 seconds.

RGB

				RGB2	Input mode
				RGB	Signal mode
		H :	48.4kHz
					Input horizontal frequency
		V :	60.1 Hz
Off-timer					Input vertical frequency
	OFF -- -- Min.
On-timer	-- -- : -- --

ENGLISH

15