CHAPTER 1: Getting Started
18
Continue to next page...
English
3Tap on .
The [Main] screen appears after approximately three
minutes.
4Reset the Pocket Controller.
(→ “Resetting the Pocket Controller” below)
Resetting the Pocket Controller
When rebooting cannot be performed or the Pocket
Controller does not work correctly even after rebooting,
follow the procedure below.
1Turn the Disklavier off.
(→ pg. 6 “Turning the Disklavier Off (Standby
Mode)” in “Quick Guide”)
2Connect the AC adapter to the AC adaptor jack, and
then set the battery replacement switch to the
[REPLACE BATTERY] position.
3Wait for five seconds, remove the battery
compartment lid, and then press the [RESET] button
with the stylus pen.
4Replace the battery compartment lid, and then set the
battery replacement switch back to the [NORMAL
OPERATION] position.
5Press to turn the Pocket Controller on.
The [Main] screen appears after approximately two
minutes.
NORMAL OPERATION
REPLACE BATTERY
RESET
Pairing the Pocket Controller and the Disklavier
For normal use, this setup is not required.
1Make sure that other wireless equipment is turned off.
2Tap on [Piano Assign] in the [PRC-100 Menu]
screen.
3Move the Pocket Controller close to the Disklavier,
and then tap on .
4Tap on .
5Tap on on the [Assigned successfully] screen.
The [PRC-100 Menu] screen resumes.
Note: Do NOT abort the procedure before step 4.
Otherwise you cannot control the Disklavier.
ESS-ID number
AdvancedManual.book Page 18 Friday, May 23, 2008 11:45 AM