CONTROLS AND THEIR FUNCTIONS

2Display

The display shows various settings, selected input source, sound field program and various other information.

3DSP key [front panel] ON/OFF key [remote control]

This key activates the sound field programs produced by the internal DSP.

4P-SET key () [front panel] PRESET key [remote control]

This key changes the display status of the built-in FM tuner from the frequency display mode to the preset tuning mode.

If the tuner is already in the preset tuning mode, each press of this key changes the group of preset stations (A, B, C, D, E).

*This key works only when the tuner is selected as the input source.

5/ (Down/Up) keys

These keys are used for selecting sound field programs, changing station frequencies, selecting preset station numbers, etc.

6Volume control [front panel]

VOLUME (Down/Up) keys [remote control]

These control and keys adjust the speaker and headphone volume. The volume cannot be adjusted when this unit is in the standby mode.

7Headphone jack

Stereo headphones can be connected to this mini-jack for private listening, with Virtual 3D effects specifically tailored for headphone listening.

8Power switch () [front panel] POWER key [remote control]

Each click of this switch changes the status of this unit between standby mode and power on.

*In the standby mode, this unit can be turned on remotely from your computer, using the supplied Application Software. Note that this unit uses a small amount of power in the standby mode.

9MEMORY key

This key is used to store a desired station in the memory.

*This key works only when the tuner is selected as the input source.

ATEST key

This key is used to output a test tone. The test tone is used when adjusting the volume balance among all speakers in the system including the virtual surround speakers. (Refer to page 19 for details.)

BCustom keys (A, B, C)

These keys are available when this unit and your computer are connected with the USB cable, and the supplied Application Software is installed on the computer.

Each of these keys can be programmed with a set of commands (input selector, sound field program, volume setting, etc.) by using the Application Software. After storing, simply pressing each key will execute the stored command.

*Refer to the online help of the Application Software for details.

CMUTE key

This key is used to cut off sound output temporarily. Turning the volume control on the front panel or pressing the VOLUME keys on the remote control restores sound output. Pressing this key again also restores sound output.

*Sound output will also be restored by changing the status of this unit between standby and power-on, changing the input source or the sound field program, and so on.

DMANUAL key

This key changes the display status of the built-in FM tuner from the preset tuning mode to the frequency display mode.

*This key works only when the tuner is selected as the input source.

ETuning/ (Down/Up) keys

These keys work in the following ways according to the status of the tuner.

In the frequency display mode:

Each press of selects a higher frequency and selects a lower frequency.

In the preset tuning mode:

Each press of selects a higher preset station

number and selects a lower preset station number.

CONTROLSFUNCTIONS THEIR &

0Sound field program selector keys

Each of these keys selects the corresponding sound field program.

English

E-7